How do you get rid of sulfur smell in well water?
Shock your well with chlorine bleach or hydrogen peroxide to get temporary relief from sulfur odors. Often keeps odors away for 1 – 2 months. 2. Chlorinator: Install a chlorine injector system (chlorinator) on your wellhead for continuous injection of chlorine when the water is running.
Is it safe to drink well water that smells like sulfur?
In most cases drinking water that has a strong rotten egg odor, although particularly unpleasant, is perfectly safe to drink. However in some rare occasions the odor may be caused by sewage or other contaminates in a building’s water supply, which could cause health problems.
How do you get rid of the smell of well water?
Increase the water heater temperature to 160 degrees Fahrenheit (71 degrees Celsius) for several hours. This will destroy the sulfur bacteria. Flushing to remove the deceased bacteria after treatment should control the odor problem.
Can I pour bleach down my well?
Mix 2 quarts bleach in 10 gallons of water; pour into well. Connect a garden hose to a nearby faucet and wash down the inside of the well. Open each faucet and let the water run until a strong chlorine odor is detected, then turn it off and go to the next one. … Pour it into the well without pumping.
Is it safe to shower in water that smells like sulfur?
It’s perfectly safe to shower in sulfur water. Doing so won’t endanger your health or wellbeing. Having said that, the presence of sulfur water in your plumbing might cause it to rust or corrode over time. Especially if the sulfur water contains high amounts of hydrogen sulfide.
How often should you chlorinate your well?
every 3 to 5 years
Homeowners with private wells should have their well water tested every 3 to 5 years for some contaminants, including bacteria. If these tests turn up positive for bacteria, chlorinating the well may be a way to resolve the problem.
Is smelly well water safe?
Start Monitoring Your Water
In most US households, though, drinking sulfur water is safe because the concentration of sulfates and hydrogen sulfide is low. With that said, sulfur in water can cause problems with your plumbing, stain your fixtures, and lead to unpleasant odors and tastes.
Why does sulfur smell like rotten eggs?
Eggs are very high in two proteins, globulin and keratin. When globulin begins to decay, a toxic chemical is released that’s called hydrogen sulfide, which has that very potent sulfur smell. … Both of these proteins release that sulfurous smell, resulting in an odor that immediately tells you that this egg has gone bad.
Can you put too much chlorine in a well?
Do not use excessive amounts of bleach – more is not more effective. 5) For best results the bleach should be combined with water before adding it to the well. [By reducing the concentration there is less chance of corrosion of the cables and pipes in the well.
How long should you wait to drink water after you chlorinate a well?
Step 6 WAIT at least 12 hours before turning faucets back on. Do not drink, cook, bathe, or wash with water from your faucets during this time because it has high amounts of chlorine in it.
How long does it take to get chlorine out of well water?
It can take 30 minutes to 24 hours or more to flush all of the chlorine from the well. ►Once the chlorine is gone from the well, open up each fixture one at a time until the chlorine smell is no longer present. This will purge the remaining chlorine from the water system.
Should you put Clorox in your well?
Disinfecting Your Water
You can disinfect your well with household chlorine bleach such as Clorox, Purex or a generic brand. The chlorine in the bleach kills bacteria. Note that it may take more than one chlorination for your well to return a satisfactory test. … To disinfect your well follow this procedure.
How do you sanitize a well?
Why does my well water turn brown when I add bleach?
The brown is the iron in the water that has oxidized as a result of the chlorination. Normally, the iron in water is in ion form and does not display itself until it combines with oxygen and forms common rust which turns the water reddish-brown.
Can I use pool shock in my well?
Chlorine granules, tablets and liquid chlorine in the form of household bleach can all be used to disinfect your well. Don’t use stabilized swimming pool chlorine products or non-chlorinated “pool shock” products, as they are not effective enough to clean your drinking water.
How much Clorox is needed to disinfect a well?
CALCULATE AND POUR: Pour 3 pints of chlorine bleach per 100 gallons of water plus an additional 3 pints into your well as described above. MIX: Attach a clean garden hose to the outdoor faucet nearest the well and place the end of the hose inside the well.
How do I chlorinate my well?
Is it OK to put chlorine tablets in a well?
Pool chlorine tablets can be used in wells. Ground wells require maintenance just as other household components and one of the most important tasks is disinfecting it. Disinfecting a ground well involves adding chlorine which kills bacteria and microscopic organisms living in the water.
How much does it cost to shock treat a well?
How much does it cost to shock a well? If you hire a company to do it, it can cost anywhere around $100 depending on where you live. Doing it yourself will only cost as much as the chlorine, 10 gallon bucket and the safety supplies to do it.
Does well water have chlorine?
Is Well Water Good for You? Private well owners do not have their water treated with chlorine or chloramines from the local water utility company. Because well water is not treated with chemicals designed to deal with organic contaminants, well water carries a higher risk of bacterial or viral infection.
What maintenance is needed for a well?
Keep hazardous chemicals, such as paint, fertilizer, pesticides and motor oil away from your well. Periodically check the well cover or well cap on top of the casing (well) to ensure it is in good repair. Always maintain proper separation between your well and buildings, waste systems, or chemical storage facilities.