How do I determine my arrow length?
The standard way to measure arrow length is from the back of the point to the throat of the nock. Your draw length and arrow spine will influence your arrow length. If you’re a 28-inch draw length and want an arrow that ends at the front of the riser, your arrow length would be around 27 inches.
How long should my arrows be for a 29 inch draw?
it depends on the arrows you choose, you need at least 1/4″ of arrow overhang on the rest. so you can probably shoot an arrow that’s about 28 1/4 for rests that are set up normally. and go all the way up to full length 36″ arrows for indoor. i would suggest 1″ of overhang on your rest.
How long should my arrows be for a 27 inch draw?
The arrow must be 29″ in length and supported by two points, which are 28″ apart. The number of inches the arrow deflects or bends due to the weight, is the spine size or measurement of an arrow. DYNAMIC spine describes the way an arrow reacts from the stored energy of a bow as it is shot.
Can arrows be too long?
The longer the arrow, the weaker the spine. So to answer your question, yes an arrow can sometimes be too long. The spine cannot be weaken by the arrow being too long – the spine is based on the deflection of a 1.98 weight hung from the middle when suspended 28″ between two points.
What size arrows for a 30 inch draw?
How to: Select the perfect arrow
| Bow | Arrow length | |
|---|---|---|
| Draw weight lb. | 25″ | 30″ |
| 15-20 | 700 | 600 |
| 20-25 | 700 | 500 |
| 25-30 | 700 | 500 |
•
Jan 7, 2015
How long should your arrow be compared to draw length?
So on most setups, it’s perfectly acceptable to use an arrow that is slightly shorter than the bow’s adjusted draw length. As long as the arrow sits comfortably beyond the arrow rest (we like to see 1″ minimum overhang), then the arrow length is sufficient.
What happens if your arrows are too lightly or heavily spine for your bow?
Every arrow shaft has a degree of stiffness called spine, which is its resistance to bending. … If your arrows are too lightly or heavily spined for your bow, the “archer’s paradox” movements will be extreme, resulting in poor arrow flight and loss of accuracy.
How do I know if my bow is drawn too long?
The bow arm should move toward the target when the shot is fired. If the bow arm drops or swings to the side, the draw length is probably too long. When this happens, the scapula has already pushed the bow arm out as far as it can extend before the arrow is released.
Can you shoot arrows longer than draw length?
Length of arrow is important to get the correct spine. If you have everything perfect now but you want the arrow longer realize that the longer length will weaken the spine of your arrow. You may weaken it to the point that you might need a stiffer spine or a lighter weight head.
How do I know if my arrows are too stiff?
The best way to tell if an arrow is too stiff or too weak is to videotape the flight of the arrow. Watching the flight of your arrow, you’ll be able to see if the arrow is veering to the right (too weak) to the left (too stiff).
Is a stiff arrow better?
Arrroman said: Too stiff an arrow usually just slows the bow down with a heavier arrow. Too weak a spine arrow usually yeilds a faster lighter arrow. But the light spine cause the arrow to shoot way off the mark as the range increases.
What does 400 mean on arrows?
The numbers refer to the spine of the arrow. The different spines refer to the stiffness, a 400 spine arrow is generally for bows 40-60 lbs. 350 spine is for bows roughly 55 – 75 lbs, and a 500 spine arrow is for bows roughly 30 – 50 lbs.
Are 340 or 400 arrows heavier?
That’s why Gold Tip recommends a 400 spine for a 27-inch arrow with a 100-grain point shot from a 60-pound bow, but also recommends a 340-spine arrow if its length and draw weight stay the same, but its point weighs 150 grains. … Arrows with weaker spines generally weigh less than those with stiffer spines.
Why do my arrows wobble in flight?
Mechanical release aids remove the left-right waggle, but the pressure comes in the vertical plane (from the string), and the rest only contacts the arrow from the bottom – meaning the arrow wobbles up and down.
Can I shoot a stiffer spine arrow?
Shooting an arrow that is not stiff enough, or a group of arrows that vary in stiffness, will cause you to be less accurate. An under-spined arrow will veer right, while an arrow that is too stiff will favor slightly left.
What weight arrows should I shoot?
If you want to target practice, you want the arrow to weigh in total (shaft, vanes, insert, nock and field point combined) around 5 to 6 grain per pound of draw weight. So if your bow has 60 lbs. of draw, you want to use arrows that weigh in total between 300 and 360 grain.
How do I find my actual draw length?
To measure your draw length, stand with your back to a wall stretching your arms out against the wall. Measure the distance from the end of your middle finger to the end of your other middle finger, basically the length of both arms, hands and chest. This measurement, minus 15 then divided by 2, is your draw length.
What size arrow is best for hunting?
006” shaft is going to provide acceptable performance; however, you will find more arrows per a dozen that will fly inconsistently. When you start talking about accuracy at distances exceeding 50 yards you are going to find much better performance in a . 003” shaft and even more in a . 001” shaft.
Is a 500 grain arrow heavy?
For reference, light arrows weigh about 350 grains, a typical arrow weighs 420 to 500 grains, and a heavy arrow weighs over 600 grains. Bentcik said few Americans use arrows weighing 700 grains or more unless they’re shooting traditional equipment.
What arrows for a 70 pound bow?
3 Basic Arrow Weights
A light arrow has a finished weight of between 5 and 6.5 grains for each pound of your bow’s maximum draw force. A lightweight arrow for a 70-pound bow would have a finished weight (including broadhead) between 350 and 455 grains.
Do heavier arrows fly better?
Arrows come in three weight categories: light, midweight and heavy. Lighter arrows fly faster and can group more tightly, but they’re often harder to tune. Heavier arrows fly slower but resist wind better and penetrate deeper. Shooting the wrong arrow weight for a bow can damage equipment and harm the archer.
Is 400 grain arrow for deer?
400 grain arrows running 305ish fps (which is probably a bit faster than your set-up) have worked fine for me on deer. Blows right through them if placement is good. I haven’t shot elk with that set-up but wouldn’t be worried about it.
What grain arrow should I shoot for deer?
Ed Ashby recommends a much heavier setup for maximum performance, starting at 650 grains for deer-sized animals. For my personal setup, I found myself somewhere in the middle of those two trains of thought. I shoot 570 grain arrows from my 65-lb Mathews VXR with a 30-inch draw length.
What is a good arrow weight for whitetail?
Well 500 is much better than 437. If anyone is on the fence with arrow weight. They should think about mature whitetail deer and their bone density. A sharp fixed blade with high foc over 20% and a combined weight at 550 is starting to get right, anything under that begins to be less than ideal for pass throughs.
Is a 450 grain arrow too heavy?
I’m sure it’s great for your purposes, but I hunt elk every few years, other than that it’s strictly whitetails, and for whitetails a 450 grain arrow is plenty heavy. (In my experience) I’ve only ever gotten pass-through shots on every deer I’ve shot. It works for me, for now anyway.