How do i reset my xerox workcentre 5335

How do I factory reset my Xerox printer?

Reset the Printer to Factory Defaults
  1. At the printer control panel, log in as administrator. At the printer control panel, press the Log In button. Touch or type admin. …
  2. Press the Home button.
  3. Touch Device > Resets.
  4. Touch Reset to Factory Defaults.
  5. At the confirmation message, touch Reset.

How do you clear error codes on Xerox?

Locate the Image Quality button, below the Auto on the Control Panel, toward the left side. Press the buttons in the following sequence within 4 seconds. Press [C] (Clear), press [Image Quality], press [C] (Clear) again, press [Image Quality] again. The error code should disappear.

How do I reset my Xerox admin password?

At the control panel touch screen, touch Device, then touch Tools. Touch Security Settings > Change Admin Password. If changing the password, type the old password. Type the new password, then type the password again to verify.

How do I find my Xerox activation code?

To enable your printer for your purchased plan, contact your Xerox equipment supplier to get a Supplies Activation Code. Contact a Xerox representative to get your supplies plan activation code. For more information about Xerox supplies and service plans, contact your Xerox Sales representative.

How do I reset my Xerox workcentre 5755?

  1. Login as the System Administrator or Key Operator. …
  2. Press the Machine Status button on the Control Panel. …
  3. Select the Tools tab on the Touch Screen.
  4. Select the Trouble Shooting button. …
  5. Select the Software Reset option.
  6. Select the Reset Both button. …
  7. Select the Confirm button. …
  8. Logout of the printer.

What is Xerox admin password?

1111
NOTE: The default user ID is “admin” (case sensitive). The default passcode is “1111”. Contact your System Administrator if there is a problem with the password, or the password has been lost or forgotten. If the password cannot be recovered, contact Support to place a service call.

How do I factory reset my Xerox 3345?

To restore your printer to factory default settings, perform the following steps:
  1. In Xerox® CentreWare® Internet Services, click Status→General.
  2. To restore the original network default settings, click Network Factory Default.
  3. To confirm, click OK.

What is the default password for Xerox workcentre 6515?

Type the administrator password, then touch OK. The default password is 1111. To log in to the Embedded Web Server as the administrator: 1.

How do I log into Xerox WorkCentre?

Login to CentreWare Internet Services as the Administrator:
  1. Select Login at the top right corner of the page..
  2. Enter the Administrator account name into the Username Field.
  3. Enter the Administrator account password into the Password field. NOTE: The default username is admin and default password is 1111. …
  4. Select Login.

How do I find my Xerox admin password?

The initial default password can be 1111 or the serial number of the printer, which can be found on the serial number label on the back of the printer. IMPORTANT: Xerox recommends that you change the default system administrator password after you configure the printer.

What is Kyocera default password?

Model No. Default Admin Name Kyocera Command Centre Password
FS-4100DN 4500 Admin/Admin (User name/Password)
FS-4200DN 5000 Admin/Admin (User name/Password)
FS-4300DN 6000 Admin/Admin (User name/Password)
FS-1028MFP 2800 admin00
You May Also Like