TABLE OF CONTENTS
Abstract
CHAPTER ONE
1.0 Introduction
1.1 Background of Study
1.2 Statement of Problems
1.3 Research Objectives
1.4 Research Question
1.5 Research Hypothesis
1.6 Scope of Study
1.7 Significance of study
1.8 Limitation of study
1.9 Definition of terms
CHAPTER TWO
2.0 Literature Review
CHAPTER THREE
3.0 Research methodology
3.1 Research Design
3.2 Population of study
3.3 Sampling Design and Procedure
3.4 Data Collection Instrument
3.5 Administration of Data Collection Instrument
3.6 Methods of data analysis
CHAPTER FOUR
4.0 Data Presentation and Analysis
4.1 Data Presentation
4.2 Test of Hypothesis
CHAPTER FIVE
5.0 Summary, Conclusion and Recommendation
5.1 Summary
5.2 Conclusion
5.3 Recommendation
References
Questionnaire
ABSTRACT
This project work deals on the design and construction of an Rf based remote control for an electronic/electrical device say electric lamp with the aim of switching on/off of the lamp at discretion and from a distance. It also eliminates the inconveniences associated with manual switching of lamps. This electronic system is designed in two functional units; the transmitter and the receiver using radio frequency (RF) communication wave band. The transmitter is a hand-held remote control while the receiver consists of a tuned radio frequency receiver, clock generator, delay circuit, flip-flop and a driver circuitry and electromagnetic relay which actuates the load (lamp). When the remote control button is pressed, the lamp comes ON and remains ON until the remote is pressed again – it goes OFF. Many advantages are accredited to this design in terms of robust, durability, cost effectiveness and components availability. The result being the simple design of a system easy to operate and maintain. A miniaturized design of it will be a reliable, robust and rugged consumer electronics that will sell like a German burger.